|
|
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
|
|
 |
The TBM6BSCR has a jaw covered with a rubber boot designed to provide some insulated protection against "brush" contact with energized cables. The tool should not be used as an insulated tool since the dies and die holding pins are always exposed.
The head can be turned 180° degrees and positioned to accommodate the operators work methods. A complete cycled compression is accomplished by the simple squeeze of a trigger. A factory preset by-pass cartridge assure a complete compression every time. Its 6-ton output is equal to any comparable handheld, hydraulic compression tool and far exceeds any mechanical crimper. The TBM6BSCR accepts Kearney, or T & B type dies. The output pressure, of the REC-CN458 can be checked with the T&B, TBM6MG pressure gauge when necessary.
|
|
|
|
|
|
 |
 |
|
 |
 |
 |
 |
|
 |
 |
|
|
|
|
